Abnormal termination of job

bansal_deep1 · Post by **bansal_deep1** » Tue Mar 13, 2007 9:53 am

I am trying to run a job but this is aborting with error in the log "Abnormal termination of stage ********** detected". Same job was fine a day before, not sure what went wrong.

Please share if any clue on this.

Thanks

DSguru2B · Post by **DSguru2B** » Tue Mar 13, 2007 9:55 am

Welcome Aboard,
Reset the job and see if any message "From previous Run" pops up. Post your finds here.

bansal_deep1 · Post by **bansal_deep1** » Tue Mar 13, 2007 1:31 pm

I reset the job, but there was no pop up of message. There was nothing like this in log file also. Should I make some setting change to get that message poped up?

Also, as per details from other post related to this, tried following things but they did not help.

- Setting of 'performance' tab parameters.
- Cleaning of &PH&.
- Import the job again from the other environment where this job is working perfectly fine.

Thanks

DSguru2B · Post by **DSguru2B** » Tue Mar 13, 2007 1:35 pm

When I said "pops up", I actually meant, if any message gets logged in the log file. Its a figure of speech. Anyways.
Give us more details of your job design, are you using inter-process buffering or IPC stage etc. Need more info.

Cr.Cezon · Post by **Cr.Cezon** » Wed Mar 14, 2007 9:27 am

When you run the job look in &PH&, there you can see what is happend.

kcbland · Post by **kcbland** » Wed Mar 14, 2007 9:33 am

Abnormal terminations mostly happen when a NULL value is used in a mathematical calculation.