Hi,
We have installed 8.1 but when I opened transformer stage in a new parallel job, it is just like a server transformer.
To be clear, parallel transformer must have 3 tabs namely Stage, Inputs and Outputs and it should have option to set RCP, but this transformer is just like a server transformer, one single page.
Why it is appearing so? Did we miss installing something?? Any suggestions would be greatly appreciated.
Thanks.
parallel transformer
Moderators: chulett, rschirm, roy
-
ray.wurlod
- Participant
- Posts: 54595
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Welcome aboard.
The Transformer does look the same, initially.
One obvious difference is that you won't be able to connect a second (reference) input to a parallel Transformer stage.
Just as with the server Transformer stage, you don't get to see the tabs until you open the stage properties. Either right-click in the background of the design area of the stage, or click the leftmost tool on the stage's toolbar.
The Transformer does look the same, initially.
One obvious difference is that you won't be able to connect a second (reference) input to a parallel Transformer stage.
Just as with the server Transformer stage, you don't get to see the tabs until you open the stage properties. Either right-click in the background of the design area of the stage, or click the leftmost tool on the stage's toolbar.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.