No Build Tab in Parallel Build stage

Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.

Moderators: chulett, rschirm, roy

Post Reply
andert1
Participant
Posts: 2
Joined: Tue Oct 31, 2006 2:52 pm
Location: Minnesota

Post by andert1 »

Well, I figured it out, it's been a while since I had used a build op. I needed to create/compile and save the buld-op in the stage type area. Once that was done I could drag into the job for further use. :oops:

ta
Top
ray.wurlod
Participant
Posts: 54595
Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:
Contact ray.wurlod

Post by ray.wurlod »

You could have asked someone else at your site (if it's WF) - there's a lot of experience there.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Top
Post Reply

Return to “IBM<sup>®</sup> DataStage Enterprise Edition (Formerly Parallel Extender/PX)”