How can I monitoring a file all the time.

A forum for discussing DataStage<sup>®</sup> basics. If you're not sure where your question goes, start here.

Moderators: chulett, rschirm, roy

Post Reply
chulett
Charter Member
Charter Member
Posts: 43085
Joined: Tue Nov 12, 2002 4:34 pm
Location: Denver, CO

Post by chulett »

I would probably end up scripting this - run the script 'eternally' and when it detects the file, launch the job, make sure all goes well and then go back to monitoring.
-craig

"You can never have too many knives" -- Logan Nine Fingers
Top
ray.wurlod
Participant
Posts: 54595
Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:
Contact ray.wurlod

Post by ray.wurlod »

You also need to incorporate a mechanism for shutting down the "eternal" job for those occasions when you need to stop the Engine.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Top
Post Reply

Return to “General”