DSXchange

Hi,
Installation seems to have went fine but dsrpcd is not comming up.
Any Ideas???

Well, then that typically means the port is in use from what I recall. Can you guess what advice is coming next?

Search the forum. Look for posts on the same subject, specifically with the keyword 'debug' in it. Something about adding a 'd9' flag? That will cause the process to log the reason for its failure and we can go from there for an actual resolution.

Well a search with HP in it came up 4 posts no real info there Craig

But I'll Take your offer on the Debugg

some times lack of time leads to memory black-out (on the debug )

the sysadmins says the port is not used -was the first thing I thought of as well

Thanks will tell them to try it ,

link not getting to the post it turns me to a forum page with posts ((((

I'll try to find that Debug issue

Here's one from when I had the same problem. Hope it helps.

Thanks Craig

Well it seems that the NIS was not properly configured

After they properly configured it the dsrpcd came up