Install on hp-ux 11 dsrpcd not up

roy · Post by **roy** » Mon May 02, 2005 6:47 am

Hi,
Installation seems to have went fine but dsrpcd is not comming up.
Any Ideas???

chulett · Post by **chulett** » Mon May 02, 2005 6:52 am

Well, then that typically means the port is in use from what I recall. Can you guess what advice is coming next? :wink:

Search the forum. Look for posts on the same subject, specifically with the keyword 'debug' in it. Something about adding a 'd9' flag?

That will cause the process to log the reason for its failure and we can go from there for an actual resolution.

roy · Post by **roy** » Mon May 02, 2005 7:03 am

Well a search with HP in it came up 4 posts no real info there Craig

But I'll Take your offer on the Debugg

some times lack of time leads to memory black-out (on the debug

)

the sysadmins says the port is not used -was the first thing I thought of as well

Thanks will tell them to try it ,

roy · Post by **roy** » Mon May 02, 2005 7:05 am

link not getting to the post it turns me to a forum page with posts

((((

I'll try to find that Debug issue

chulett · Post by **chulett** » Mon May 02, 2005 7:08 am

Here's one from when I had the same problem. Hope it helps.

roy · Post by **roy** » Mon May 02, 2005 7:11 am

Thanks Craig

Well it seems that the NIS was not properly configured

After they properly configured it the dsrpcd came up