Unable to see the Status of Performance after execution

Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.

Moderators: chulett, rschirm, roy

Post Reply
apraman
Participant
Posts: 47
Joined: Mon Sep 12, 2005 5:26 am

Unable to see the Status of Performance after execution

Post by apraman »

Till last day, in DS Designer, after successfull completion of a job,
the Performance status - number of rows and the transfer rate for each link was being displayed.
But today I am unable to view this, during the execution the colour of the link does not even changes .

When I check the Log of the Job there are certain entries which says

"SQF_result,0: Export complete. 10 records exported successfully, 0 rejected."

And there is warning message too

"Failed to connect to JobMonApp on port 13401"

And i am getting my result perfect

Can any one tell me how to solve it
Last edited by apraman on Tue Oct 18, 2005 12:21 am, edited 1 time in total.
Arun
ray.wurlod
Participant
Posts: 54607
Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:

Post by ray.wurlod »

Start the job monitor. It's stopped for some reason.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
apraman
Participant
Posts: 47
Joined: Mon Sep 12, 2005 5:26 am

Post by apraman »

ray.wurlod wrote:Start the job monitor. It's stopped for some reason.
Thanks Ray,

I have started the Job Monitor and it works fine.

I also got some vital information regarding Job Monitor in the following Posts

viewtopic.php?t=92922&highlight=Job+Monitor

viewtopic.php?t=94901&highlight=Job+Monitor

viewtopic.php?t=94314&highlight=Job+Monitor

viewtopic.php?t=87373&highlight=Job+Monitor
Arun
Post Reply