Address verification interface on grid

Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.

Moderators: chulett, rschirm, roy

Post Reply
peep
Premium Member
Premium Member
Posts: 162
Joined: Mon Aug 20, 2012 6:52 pm

Address verification interface on grid

Post by peep »

did any one setup AVI on Grid environment ?

We have installed AVI ,it is working fine in non grid but fails wen grid is enabled.
ray.wurlod
Participant
Posts: 54607
Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:

Post by ray.wurlod »

What error messages do you see? Have you properly provisioned all the required components?
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
PaulVL
Premium Member
Premium Member
Posts: 1315
Joined: Fri Dec 17, 2010 4:36 pm

Post by PaulVL »

I have AVI in a grid. works fine.

11.3 fp2 is my setup.
peep
Premium Member
Premium Member
Posts: 162
Joined: Mon Aug 20, 2012 6:52 pm

Post by peep »

I have changed few permissions on lib's and it worked.
however I get Resource bundle correspoding to message key DSEE-AVIF not found. check that DSHOME or APT_RESPATH is set .
ray.wurlod
Participant
Posts: 54607
Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:

Post by ray.wurlod »

And have you checked that one or both of these environment variables is set for the executing user? (Tip: the second event in the job log will display environment variable values.)
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
peep
Premium Member
Premium Member
Posts: 162
Joined: Mon Aug 20, 2012 6:52 pm

Post by peep »

opened a service ticket . support said its not worth involving engineering on this warning message .
it is seen on all machines where AVI is installed in GRID environment.
so suggested to suppress the warning message .
PaulVL
Premium Member
Premium Member
Posts: 1315
Joined: Fri Dec 17, 2010 4:36 pm

Post by PaulVL »

Wow, bad idea IMHO.

Dig deeper to see why that warning message is being thrown, don't sweep it under the carpet.

Run a job with APT_GRID_ENABLE=NO (make your config file point to head node only)
then run it with YES.

Make sure your QSAVI repository mount is accessible to the compute nodes.
Make sure the user id running the job has read access to it.
ETC...
peep
Premium Member
Premium Member
Posts: 162
Joined: Mon Aug 20, 2012 6:52 pm

Post by peep »

So we have QSAVI DB files placed on all compute nodes with 777 .
gave 777 -R to QSAVI in DSComponent directory .
Ran job with APT_GRID_ENABLE=NO job log has same warning messages , Ran job with APT_GRID_ENABLE=YES job log has same warning messages.
PaulVL
Premium Member
Premium Member
Posts: 1315
Joined: Fri Dec 17, 2010 4:36 pm

Post by PaulVL »

But was your default APT file limiting the execution to the Head Node only? No compute node spanning.

Make it a 2 node setup on Head Node.

If you still get the warning, then you know it has nothing to do with grid and spanning boxes.
Post Reply