Validating address using CASS

Infosphere's Quality Product

Moderators: chulett, rschirm

Post Reply
kennyapril
Participant
Posts: 248
Joined: Fri Jul 30, 2010 9:04 am

Validating address using CASS

Post by kennyapril »

I have to design a job in which the source contains 1 million of addresses and the target should be the validated addresses from the source.

For this validation

source----->cass----->standardization----->target

or
Source------>standardization--------->cass------->target

please let me know which should be followed in the above ways or any suggestions!!
Regards,
Kenny
jaksani
Participant
Posts: 48
Joined: Tue Mar 01, 2011 12:26 am
Location: Hyderabad

Post by jaksani »

Second step
Source------>standardization--------->cass------->target
is correct.
Thanks & Regards,
Venkat Jaksani
kennyapril
Participant
Posts: 248
Joined: Fri Jul 30, 2010 9:04 am

Post by kennyapril »

Thanks for the information!!

CASS does the standardization of address and If the input has a name then name should be standardized with standardize stage.

If the case is the input has only address1,address2,city,state,zip
Do I need standardize stage or Just the CASS stage?


any info please?
Regards,
Kenny
lstsaur
Participant
Posts: 1139
Joined: Thu Oct 21, 2004 9:59 pm

Post by lstsaur »

CASS stage only. Also study the tutorial job for CASS under the installation folder. Its input source, Excel spread sheet, has exactly the fileds that you specified.
kennyapril
Participant
Posts: 248
Joined: Fri Jul 30, 2010 9:04 am

Post by kennyapril »

Thanks Istsaur.

which Installation folder is that?

Is it under documentation?
Regards,
Kenny
lstsaur
Participant
Posts: 1139
Joined: Thu Oct 21, 2004 9:59 pm

Post by lstsaur »

No, it's in e.g. C:\is-ia-suite\TutorialData\QualityStage.
kennyapril
Participant
Posts: 248
Joined: Fri Jul 30, 2010 9:04 am

Post by kennyapril »

Yes I see a .dsx file in that folder,I imported the same but that tutorial has no CASS job It has only investigate,standardize,survive,unduplicate.


any other info please?
Regards,
Kenny
lstsaur
Participant
Posts: 1139
Joined: Thu Oct 21, 2004 9:59 pm

Post by lstsaur »

Sorry, I have been away from QS especially using CASS for too long. As you said in QualityStage folder, it contains all other stages except the CASS stage. That brings back the memory, actually the tutorial job for CASS is contained in the .tar file for CASS.
kennyapril
Participant
Posts: 248
Joined: Fri Jul 30, 2010 9:04 am

Post by kennyapril »

Searched all the files but no luck.

I looked into a folder named IS_CASS Files in C:\ but did not find the job.

There are .tar files named CASSDBM1,CASSDBM2...and so on...untared them but cannot see any .dsx file.
Regards,
Kenny
Post Reply