Page 1 of 1
ORA-39767: finish is not allowed when unloaded stream data
Posted: Sat May 20, 2017 2:01 am
by koti9
Hello all,
I am getting ORA-39767 while doing a bulk load from a fileset to Oracle DB using connector. I searched online and dsxchange with no luck. Please let me know if you ever faced this and solved it? Thanks a lot for your help in advance.
Thanks & Regards
Koti
Posted: Sat May 20, 2017 5:47 am
by Timato
This sounds like an Oracle issue....
Have you checked out:
viewtopic.php?t=132761
And from that post there should be a row/column number which you can investigate to make sure its valid.
Posted: Sat May 20, 2017 7:32 am
by chulett
To me it sounds like a connector bug, especially if you are still on an 8.x release. In your shoes I would involve your official support provider to help determine what's going on, which which is which.
May be not an Oracle Connector Bug
Posted: Sat May 20, 2017 7:37 pm
by koti9
Hi Craig/Timato,
I did load the problematic fileset into a flat file and successfully loaded into Oracle using Connector via BulkLoad. I dont believe its problem with Oracle Connector.But i think its either problem with fileset or dataset.I am getting error with both Fileset and Dataset. Please let me know if there is any other issue (like i need to overwrite any other fileset/dataset environment variables)
Thanks & Regards
Koti
Posted: Sun May 21, 2017 7:14 am
by chulett
If it can load the same data from source A but not source B or C, it still smells like a connector issue to me. Simple enough to check with support to find out.