Trying to install sap pack onto client install 11.5 fp 2. Installation instructions say to run setup from is-suite (which doesn't exist), so ran from under is-client. But it never lets you get to screen to add additional products... I suspect fp2 install did this. error msg: 'The installation program has detected an existing client installation at given location...'
I had done installs this way a while ago on another machine and didn't have this issue (but it had been prior to installing fp2).
Any suggestions would be appreciated!!
Installation failure (client) - can't add product (SAP Pack)
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 10
- Joined: Mon Jun 01, 2015 3:39 pm
- Location: Northern New Jersey
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
The is-suite directory contains software for the engine, services and repository tiers. It will exist on the computer(s) that host those tiers. If you have deleted it, restore from backup or unpack from archive downloaded from Passport Advantage.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 10
- Joined: Mon Jun 01, 2015 3:39 pm
- Location: Northern New Jersey
-
- Participant
- Posts: 10
- Joined: Mon Jun 01, 2015 3:39 pm
- Location: Northern New Jersey
fyi: I suspect it was FP2 related, I completely uninstalled InfoSphere and then installed part CNK0MML (full install which includes fix pack 2, as opposed to what I had done full install 11.5.0.0 then fix pack on top of it). I can now install additional products.
Hope this helps others if they encounter similar issues.
Hope this helps others if they encounter similar issues.
Thanks! Sean