HELP ... !!!

[admin]

I've seen the problem and you're bringing back a lot of painful memories.
Similar thing... Worked fine for quite some time, worked fine in several
projects and suddenly in one project - these 'put' failures. And *then* for
me only to certain hosts - switching hosts would cause the put error to come
and go. Very frustrating.

Ascential support finally came back and said I was having the problem
because I was ftp'ing multiple files at the same time. In spite of the fact
that I *should* have been perfectly able to do it (and had been doing it for
two years at that point), when I changed the job to ftp them one at a time
in a 'serial' fashion the problem went away.

Don't know if that is *your* problem, but hopes this helps.

-craig

-----Original Message-----
From: Kedar R. Terdalkar [mailto:kterdalkar@egulf.com]
Sent: Friday, October 31, 2003 4:28 AM
To: DataStage Users
Subject: HELP ... !!!


Hi All,

I am trying to FTP a generated Flat file through DataStage, but I am getting
the following error and this also aborts my job and my interface:

WIASRD21FILETOFINALFtpPLUSYr..XFormWIASRDPlus: function 'ft_putline' failed.
WIASRD21FILETOFINALFtpPLUSYr..XFormWIASRDPlus: ftp_put error
WIASRD21FILETOFINALFtpPLUSYr..XFormWIASRDPlus: function 'ftp_put' failed

Has anybody encountered this problem earlier or what are the corrective
measures to be taken to resolve this problem.

Please Note that the same Job is being used through other interface and is
working perfectly fine and the flat file structure for both the Interfaces
are the same the only difference is the name of the flat file which we are
passing through the Parameters

Any help in this regard would be a big favour and a definite help.

Thanks & Regards
Kedar