Version Control Initialize puts Source job in "Read Onl
Posted: Mon Apr 20, 2009 7:23 am
Hi,
I have to initialize jobs into Version Control (I administer the toolset but am not a DataStage Developer) for an offshore team on a regular basis. On occasion, I will get an email back from the group that the Source Job in the Development Project has been set to "Read Only" mode. The only thing I have done is initialize the job into Version Control and Promote it to a QA project.
At that point the only thing I can do is promote the job from Version Control, back to the Development Project - unchecking the "Read Only" clickbox.
It doesn't happen every time, and it's usually a week before I get a report that there is something wrong - so I can't recreate the events. I only use the admin user/pass.
Has anyone else experienced this issue? If so, what was the resolution? I am on 7.5.1a (I can't upgrade my version, so the solution has to be within this installation)
I have to initialize jobs into Version Control (I administer the toolset but am not a DataStage Developer) for an offshore team on a regular basis. On occasion, I will get an email back from the group that the Source Job in the Development Project has been set to "Read Only" mode. The only thing I have done is initialize the job into Version Control and Promote it to a QA project.
At that point the only thing I can do is promote the job from Version Control, back to the Development Project - unchecking the "Read Only" clickbox.
It doesn't happen every time, and it's usually a week before I get a report that there is something wrong - so I can't recreate the events. I only use the admin user/pass.
Has anyone else experienced this issue? If so, what was the resolution? I am on 7.5.1a (I can't upgrade my version, so the solution has to be within this installation)